Xado
- Small Engine treatment (1000cc and below)
XADO
- How much is required?
The amount of XADO required
depends on he volume of oil or fuel in your engine, gearbox
or fuel tank etc. Due to the fact that each
engine has different issues, each application also requires
a different quantity of XADO to achieve lasting
results. In reality it is difficult for us to assess
your exact requirements, therefore each application is
designed to cover the worst case scenario.
This engine treatment contains
3 x 4.5ml treatments and
can be applied to any 2 stroke, 4
stroke or pre mixed
fuel and oil systems as well as equipment or engines
with separate
fuel and oil systems.
Each blister pack is applied
individually, so you do not have to purchase all
three blister packs at the same time.
Once you have
completed the full recommended treatment,
you will receive a 1 year guarantee, though
from experience the application will last
significantly longer, which in most
cases will exceed the your lifetime ownership of the
vehicle.
Note: Remember
once you have completed the full treatment our products DO NOT require re application every 20,000
miles, unlike other products on the market.
| With
combined fuel and oil system |
With
separated fuel and oil system |
| Stage
1: |
| Squeeze the
contents of one of the sachets into a full
fuel tanks. (Alternatively you can
dissolve the contents of the sachet in the
oil or fuel, you may have to gently warm the
oil or fuel to above 20 °C.)
Run the
engine as usual.
|
Warm up the
engine to the working temperature. Squeeze
the contents of one of the sachets into the
engine oil tank.
Start the engine and let it idle for 2
minutes.
Run as usual.
|
| Stage
2: |
| Repeat stage
1, when you refill the fuel tank. |
Repeat stage
1 after 150 - 250 km run or after 4 hours of
the engine operation. |
| Stage
3: |
| Repeat stage
2 |
Repeat stage
1 again after a further 150 - 250 km run or
after 4 hours of the engine operation. |
|
